Cummins Crankshaft Barring Tool. Turn over your Cummins with ease with this Cummins Crankshaft Barring Tool. It is much easier to use than the barring tool that interfaces the flywheel housing and starter ring gear.
Remove the 4 bolts holding on the damper, install this tool, reinstall the bolts, and torque to spec. You'll never back a bolt out of the damper when trying to reach TDC and overshoot.
They are especially useful when removing and reinstalling a transmission. No need to use a pry bar on the starter ring gear to rotate the engine to remove and replace converter bolts.
Accepts 1/2 inch drive ratchet
Designed to be used with factory crank bolts and roll pins
No need to remove after installed
Built from 1018 steel
Works with Vibratech Fluidampr as well as factory dampers